Jura Capresso-Impressa F7Aroma-F8TFT-J5-J6-J7-J9-XJ5-XJ9 Brew Group
Does Not Include:
- Drain Valve
- Riser Tube to Silicone Tube Connector (90 Degree)
Related Error Message:
- Drive Shaft (Brew Group Guide)
After the grinding process is complete, the coffee grounds enter the Brew Group. The Gear Motor receives the message to activate the Brew Group via the Encoder (Part #1117), which receives its information from the CPU. The Gear Motor (Part #1113) engages the Brew Group Guide (Part #1103), activating the Brew Group Infuser to compact the coffee. The Piston Gasket (Part #1104) creates an airtight seal, allowing pressure to build to its optimal level, thus beginning the Brew Cycle. The pressure creates the nice crema on top of espresso shots. When the coffee is finished brewing, the Brew Group dumps the used coffee grounds into the container and returns to its stationary position.
If your Brew Group is nearing the end of its life, then you will hear the Brew Group struggling to obtain the correct position, or notice the coffee grounds are watery when dumped into the Used Coffee Container. Replacing gaskets and lubricating the Brew Group every 6 months will drastically increase the life of the Brew Group. If you receive the "Error 8 Message," it is too late. You must purchase a new Brew Group or refurbish it.
Jura ENA Brew Group Disassembly and Reassembly